Royal Traders

OXYBON
OxyBon For FumigationOxybon unique formula is based on 35% hudrogen peroxide that has been put through a special treatment the result of which is a powerful board spectrum disinfectant that is completely safe to the environment yet leaves no unpleasant tastes or odours.
Oxybon has proven bactericidal, algicidal, fungicidal and viricial efficacy.
Areas of Use :Aerial Fumigation :- Concentration of oxyBon 4% (for 1000 cubic feet area to be fumigated with ULV fogger-i.e. 40ml Aqbon in 960ml DM water to be sprayed for 15 minutes) contact time 20-30 minutes after which the area which the area sterlie.
Surface Disinfection :- Apply 3% oxyBon on floor, walls, bench and linen working table.
Instrument Disinfection :- Dip the Instrument in a 2% solution for 10 minutes.
Resin and filter disinfection :- Dip in a 0.5% to 1% solution to control foul odur & contamination. This solution can be used to clean the membrane S of R.O.Plant.
Storage tank disinfection :- Spray the surface of the tank with 2% solution.
Laundry Cleaning & Disinfection :- Wash with 3% to 5% solution of oxyBon and  rinse with DM water.
Secondary infections  in the containers are eliminated when during bottling a continuous disinfection of the filling elements is carried out.
Features and Benifits :

• An area of 1000 cubic feet can be completely sterile within 30 minutes of spraying without causing any irritation to the eyes, nose and skin-unlike conventionally used formulations. with ULV fogger gives a very fine mist which allows the formulation to be suspended in the atmosphere for a longer period of time, guarantee a 100% kill rate of all air borne bacteria's and fungus.
• oxyBon is Eco friendly, odourless and exhibits no influence on the taste yet it has abeneficial effect on the entire air born, water born bacteria and fungus.
• oxyBon does not form any harmful or toxic by-products, since its only decomposition production products are water and oxygen. It is therefore friendly to you and your environment. 
• It remains effective through a pH range of 2-7, and through a temperature range from 0 degree C to 95 degree C. This means you no longer have to make tedious and costly pH andtemperature adjustments to ensure your disinfectant is achieving the expected results.
• OxyBon is non-foaming and has good rinse off characteristics.
• The concentration of Oxybon in "usesolutions" is measured on site using oxybon test strips.
• This method is quick, clean, simple, inexpensive and accurate.

Directions for use :-
Add OxyBon directly into the water. 

• Water disinfection 20-50 ppm (20-50mg/I)
• Dosage will be change due to depending upon water condition.

• Surface disinfection 0.5-1%
• Extreme case disinfection 2-4%

Your OxyBon technical representative will design a complete operating procedure that best meets your needs.